By the time you see a stain or hear dripping, a burst pipe has often already been running for a while inside the wall.
Insulation and drywall removal is targeted, and we coordinate directly with a licensed plumber for the actual pipe repair.
We'll walk you through shutoff steps over the phone if you call before we arrive.
We use pressure testing and moisture tracing to locate exactly where a supply line failed inside the wall.
Drywall and insulation come out only where moisture readings confirm saturation, not the entire wall.
Our Loretto, MN team works alongside your plumber or one we can refer, so the repair and drying stay coordinated.
A burst pipe call has a specific sequence — find the source, stop it, open only what's necessary, and coordinate repair — here's how our Loretto, MN crews run it.
If the source is still running, shutoff is priority one.
We locate the failure point before opening any drywall, avoiding guesswork demolition.
We extract from within the cavity itself, not just the surface that's visible.
Saturated insulation is removed and replaced, while drywall is cut only at the confirmed wet line.
We dry wall framing directly, not just the room's ambient air.
We coordinate scheduling with a licensed plumber for the pipe repair itself.
Tell our Loretto, MN dispatcher if the water source is still running so we can advise on shutoff immediately.
Equipment for wall cavity work is brought along by default for burst pipe calls.
We diagnose the leak location and provide a written estimate for extraction and drying before removal begins.
Final sign-off includes verified dry readings and a repair handoff.
"They found our shutoff valve in about thirty seconds since we had no idea it existed, then got straight to work on the wall." — Holly T.
"Only opened up the section of wall that was actually wet instead of the whole thing. Saved us a lot on drywall repair." — Andre L.
"They coordinated directly with our plumber so the pipe got fixed the same week the wall was already open." — Priscilla W.
We can confirm which you're dealing with during the initial assessment.
No, we remove drywall only at the confirmed wet line based on moisture readings.
We can refer a plumber or work alongside yours to keep the timeline aligned.
Avoid the area near standing water and electrical outlets until our technician confirms it's safe.
Wall cavity drying typically takes 3-5 days depending on how much insulation and framing was affected.
Loretto sits within our core burst pipe response zone.
One call gets a Loretto, MN crew routed to Loretto with the right equipment.
Call +1-844-578-1604